Skip to content

How To Replace Moen Faucet Cartridge 1224 B

Moen cartridge 1224 B is a quarter turn cartridge. It is used in several Moen faucets. To replace the cartridge, first shut off the water to the faucet at the valve. Then remove the handle and the escutcheon (the decorative cover). The cartridge is held in place by a retaining clip. Use a screwdriver to pry the clip off and then pull out the cartridge. Install the new cartridge by reversing these steps. Make sure to turn on

How To Replace Moen Faucet Cartridge 1224 B

Moen faucet cartridge 1224 b is a component of the faucet that helps in regulating water flow. It is usually made of brass and plastic. The cartridge is inserted into the faucet and water is allowed to flow through the small openings in the cartridge. Over time, the cartridge can wear down and start to leak. When this happens, it needs to be replaced. Here is how to do it: 1) Turn off the water supply to the

-A basin wrench -channel locks -Moentrol cartridge 1224B -New cartridge O-ring -A bucket -Replacement washers (2) -Teflon tape

  • Shut off water supply to faucet
  • Remove handle by unscrewing the set screw and pulling off
  • Remove the bonnet nut by turning it counterclockwise detach the faucet aerator by unsc

– Replacement cartridges are available from most hardware stores – To remove the old cartridge, twist it counterclockwise and pull it out – To install the new cartridge, insert it into the faucet and twist it clockwise until it is tight


Frequently Asked Questions

How Do You Remove A Moen Cartridge?

The process of removing a Moen cartridge can vary depending on the model of cartridge that is being removed. However, in most cases the cartridge can be unscrewed by hand.

How Do You Remove The Cartridge From A Moen Faucet?

The cartridge in a Moen faucet is removed by unscrewing it.

How Do I Change The Cartridge In My Moen Faucet?

The cartridge in a Moen faucet is removed by unscrewing the cap on the handle and pulling it out. The cartridge is then replaced by pushing it into the faucet and screwing the cap back on.

How Do You Remove An Old Moen Cartridge?

To remove an old Moen cartridge, unscrew the cartridge collar and pull the cartridge out.

How Do You Remove A Moen Cartridge Without A Puller?

There are a few ways to remove a Moen cartridge without a puller. One way is to use a pair of channel locks to grip the cartridge and then twist it out. Another way is to use a pair of vise grips to grip the cartridge and then twist it out.

How Do You Remove The Cartridge From A Moen 1224 Faucet?

There should be a small lever on the side of the faucet that you can use to release the cartridge.

How Do You Change A Cartridge On A Moen Faucet?

If your Moen faucet has a single-lever cartridge, you will need to remove the handle. To do this, insert a thin blade into the small slot on the top of the handle and pry it off. Once the handle is off, unscrew the cartridge by turning it counterclockwise. If your Moen faucet has a two-lever cartridge, you will need to remove the escutcheon (the decorative cover that hides the screws). To do this, twist it counterclockwise and pull it off. Once the escutcheon is off, unscrew the cartridge by turning it counterclockwise.


In The End

Replacing a Moen faucet cartridge is a relatively easy task that can be completed in about 10 minutes. First, remove the handle by unscrewing the set screw and pulling it off. Then, use a wrench to loosen the cartridge from the spout. Next, replace the old cartridge with a new one and reattach the spout and handle. Finally, tighten the cartridge and handle screws.

Leave a Reply

Your email address will not be published.